D-Link xStack DGS-3620 Series - Page 75

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
70
Example
To display the login and enable method list for all applications:
DGS-3620-28PC:admin#show authen application
Command: show authen application
Application Login Method List Enable Method List
----------- ----------------- ------------------
Console default default
Telnet login_list_1 default
SSH default default
HTTP default default
DGS-3620-28PC:admin#
4-16 create authen server_group
Description
This command is used to create a user-defined authentication server group. The maximum
supported number of server groups including built-in server groups is eight. Each group consists of
eight server hosts as maximum.
Format
create authen server_group <string 15>
Parameters
<string 15> - Enter the user-defined server group name.
Restrictions
Only Administrator-level users can issue this command.
Example
To create a user-defined authentication server group:
DGS-3620-28PC:admin#create authen server_group mix_1
Command: create authen server_group mix_1
Success.
DGS-3620-28PC:admin#
4-17 config authen server_group
Description
This command is used to add or remove an authentication server host to or from the specified
server group. Built-in server group tacacs, xtacacs, tacacs+, and RADIUS accept the server host
with the same protocol only, but user-defined server group can accept server hosts with different