D-Link xStack DGS-3620 Series - Page 769

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
764
DGS-3620-28PC:admin#
65-9 clear mac_based_access_control auth_state
Description
This command is used to clear the authentication state of a user (or port). The port (or the user)
will return to un-authenticated state. All the timers associated with the port (or the user) will be
reset.
Format
clear mac_based_access_control auth_state [ports [all | <portlist>] | mac_addr <macaddr>]
Parameters
ports - Specifies the port range to clear the authentication state.
all - Specifies all ports.
<portlist> - Enter a range of ports.
mac_addr - Specifies to clear a specified host authentication state.
<macaddr> - Enter the MAC address here.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To clear the authentication state of all ports:
DGS-3620-28PC:admin#clear mac_based_access_control auth_state ports all
Command: clear mac_based_access_control auth_state ports all
Success.
DGS-3620-28PC:admin#
65-10 create mac_based_access_control_local mac
Description
This command is used to create a database entry.
Format
create mac_based_access_control_local mac <macaddr> {[vlan <vlan_name 32> | vlanid
<vlanid 1-4094>]}
Parameters
<macaddr> - Enter the MAC address that access accepts by local mode.
vlan - (Optional) If the MAC address is authorized, the port will be assigned to this VLAN.
<vlan_name 32> - Enter a VLAN name up to 32 characters long.