D-Link xStack DGS-3620 Series User Manual

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
806
forwarded on the multicast VLAN.
none - If none is specified, the packet’s original priority will be used. The default setting is
none.
replace_priority - (Optional) Specifies that the packet’s priority will be changed by the switch,
based on the remap priority. This flag will only take effect when the remap priority is set.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To create an MLD snooping multicast VLAN with the VLAN name mv1 and the VID 2:
DGS-3620-28PC:admin#create mld_snooping multicast_vlan mv1 2
Command: create mld_snooping multicast_vlan mv1 2
Success.
DGS-3620-28PC:admin#
70-2 config mld_snooping multicast_vlan
Description
This command is used to configure MLD snooping multicast VLAN parameters. The member port
list and source port list cannot overlap. However, the member port of one multicast VLAN can
overlap with another multicast VLAN. The multicast VLAN must be created first using the create
mld_snooping multicast_vlan command before the multicast VLAN can be configured.
Format
config mld_snooping multicast_vlan <vlan_name 32> {[add | delete] [member_port
<portlist> | [source_port <portlist> | untag_source_port <portlist>] | tag_member_port
<portlist>] | state [enable | disable] | replace_source_ipv6 [<ipv6addr> | none] |
remap_priority [<value 0-7> | none] {replace_priority}}(1)
Parameters
<vlan_name 32> - Enter the name of the multicast VLAN to be configured. Each multicast VLAN
is given a name that can be up to 32 characters.
add - Specifies to add a port.
delete - Specifies to delete a port.
member_port - Specifies member port of the multicast VLAN. The specified range of ports will
become untagged members of the multicast VLAN.
<portlist> - Enter a range of ports to be configured.
source_port - Specifies source port where the multicast traffic is entering the Switch.
<portlist> - Enter a range of ports to be configured.
untag_source_port - Specifies the untagged source port where the multicast traffic is entering
the Switch. The PVID of the untagged source port is automatically changed to the multicast
VLAN. Source ports must be either tagged or untagged for any single multicast VLAN, i.e.
both types cannot be members of the same multicast VLAN
<portlist> - Enter a range of ports to be configured.
tag_member_port - Specifies the tagged member port of the multicast VLAN.
<portlist> - Enter a range of ports to be configured.

D-Link xStack DGS-3620 Series Specifications

General

Brand	D-Link
Model	xStack DGS-3620 Series
Category	Switch
Language	English