D-Link xStack DGS-3620 Series - Page 839

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
834
http - (Optional) Specifies the trusted host for HTTP.
https - (Optional) Specifies the trusted host for HTTPs.
ping - (Optional) Specifies the trusted host for Ping.
Note: If no management method is specified, the IP (range) can access the Switch
through any method.
Restrictions
Only Administrators and Operators can issue this command.
Example
To create a trusted host:
DGS-3620-28PC:admin#create trusted_host 10.48.74.121
Command: create trusted_host 10.48.74.121
Success.
DGS-3620-28PC:admin#
74-5 config trusted_host
Description
This command is used to configure the access interfaces for the trusted host.
Format
config trusted_host [<ipaddr> | <ipv6addr> | network <network_address> | ipv6_prefix
<ipv6networkaddr>] [add | delete] {snmp | telnet | ssh | http | https | ping | all}
Parameters
<ipaddr> - Enter the IP address of the trusted host.
<ipv6addr> - Enter the IPv6 address of the trusted host.
network - Specifies the network address of the trusted network. The form of network address is
xxx.xxx.xxx.xxx/y.
<network_address> - Enter the network address of the trusted network. The form of network
address is xxx.xxx.xxx.xxx/y.
ipv6_prefix - Specifies the IPv6 network address of the trusted network.
<ipv6networkaddr> - Enter the IPv6 network address of the trusted network.
add - Allow to manage applications for a trusted host.
delete - Prevent from managing applications for a trusted host.
snmp - (Optional) Specifies the trusted host for SNMP.
telnet - (Optional) Specifies the trusted host for Telnet.
ssh - (Optional) Specifies the trusted host for SSH.
http - (Optional) Specifies the trusted host for HTTP.
https - (Optional) Specifies the trusted host for HTTPs.
ping - (Optional) Specifies the trusted host for Ping.
all - Specifies the trusted host for all applications.