xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
911
Format
show ospf {[ipif <ipif_name 12> | all]}
Parameters
ipif - (Optional) Specifies the IP interface name.
<ipif_name 12> - Enter the IP interface name here. This name can be up to 12 characters
long.
all - (Optional) Specifies that all the IP interfaces will be displayed.
If no parameter is specified, the system will display the current OSPF settings.
Restrictions
None.
Example
To display the current OSPF state:
DGS-3620-28PC:admin# show ospf
Command: show ospf
OSPF Router ID : 10.90.90.90 (Auto selected)
State : Enabled
OSPF Interface Settings
Interface IP Address Area ID State Link Metric
Status
------------ ------------------ --------------- -------- --------- ---------
System 10.90.90.90/8 0.0.0.0 Disabled Link Down 1
Total Entries : 1
OSPF Area Settings
Area ID Type Stub Import Summary LSA Stub Default Cost Translate
--------------- ------ ----------------------- ----------------- ---------
0.0.0.0 Normal None None None
10.0.0.0 Normal None None None
10.0.0.1 NSSA Enabled 1 Disabled
10.0.0.2 Stub Enabled 1 None
Total Entries : 4
Virtual Interface Configuration
Transit Virtual Hello Dead Authentication Link
Area ID Neighbor Router Interval Interval Status
--------------- --------------- -------- -------- -------------- ------
10.0.0.0 10.0.0.1 10 60 None Down
To Next Page
Loading...
Need help?
General