D-Link xStack DGS-3620 Series - Page 927

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
922
DGS-3620-28PC:admin# create ospfv3 area 1.1.1.1 type normal
Command: create ospfv3 area 1.1.1.1 type normal
Success.
DGS-3620-28PC:admin# create ospfv3 area 2.2.2.2 type stub stub_summary enable
Command: create ospfv3 area 2.2.2.2 type stub stub_summary enable
Success.
DGS-3620-28PC:admin#
79-6 delete ospfv3 area
Description
This command is used to delete an OSPFv3 area. The backbone area (0.0.0.0) can not be deleted.
Format
delete ospfv3 area <area_id>
Parameters
<area_id> - Enter the OSPFv3 area’s ID here. It is a 32-bit number in the form of an IPv4
address that uniquely identifies the OSPFv3 area in the OSPFv3 domain.
Restrictions
Only Administrators, Operators and Power-Users can issue this command. (EI Mode Only
Command)
Example
To delete an OSPFv3 area:
DGS-3620-28PC:admin# delete ospfv3 area 1.1.1.1
Command: delete ospfv3 area 1.1.1.1
Success.
DGS-3620-28PC:admin#
79-7 config ospfv3 area
Description
This command is used to configure an OSPFv3 area. The backbone area (0.0.0.0) can not be
configured to be stub area.