D-Link xStack DGS-3620 Series - Page 966

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
961
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To configure PIM-SSM state and group range:
DGS-3620-28PC:admin# config pim-ssm state enable group_range default
Command: config pim-ssm state enable group_range default
Success.
DGS-3620-28PC:admin#
82-22 show pim-ssm
Description
This command is used to list all PIM-SSM protocol related information.
Format
show pim-ssm
Parameters
None.
Restrictions
None.
Example
To display PIM-SSM state and group range:
DGS-3620-28PC:admin# show pim-ssm
Command: show pim-ssm
SSM Service Model State : Enabled
SSM Group : 232.0.0.0/8
DGS-3620-28PC:admin#
82-23 show pim passive
Description
This command is used to display PIM interface passive mode.