D-Link xStack DGS-3620 Series - Page 98

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
93
Parameters
<ipif_name 12> - Enter the IP interface name used here.
<ipaddr> - Enter the IPv4 address used here.
<ipv6addr> - Enter the IPv6 address used here.
none - Specifies to revert to the default route table for all outgoing RADIUS packet.
Restrictions
Only Administrator level can issue this command.
Example
To specify an interface as the source interface for all outgoing RADIUS packets.
DGS-3620-28PC:admin#config radius source_ipif if_v200
Command: config radius source_ipif if_v200
Success.
DGS-3620-28PC:admin#
4-48 show radius source_ipif
Description
This command is used to display specified source interface for all outgoing RADIUS packets.
Format
show radius source_ipif
Parameters
None.
Restrictions
Only Administrator level can issue this command.
Example
To display specified source interface for all outgoing RADIUS packets.
DGS-3620-28PC:admin#show radius source_ipif
Command: show radius source_ipif
IP Interface : if_v200
IPv4 Address : None
IPv6 Address : None
DGS-3620-28PC:admin#