D-Link xStack DGS-3620 Series - Page 990

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
985
Prune Pending Timer : 0 sec
Prune Expiry Timer : 15 sec
DGS-3620-28PC:admin#
83-24 show pim6 mroute star_g
Description
This command is used to display the multicast routing information for (*, G) entries generated by
PIM6. Users can get detailed info of the routing entries by choosing the options in the command.
Format
show pim6 mroute star_g {group <ipv6addr> {ipif <ipif_name 12>}}
Parameters
group - (Optional) Specifies the IPv6 multicast group address.
<ipv6addr> - Enter the IPv6 multicast group address used here.
ipif - (Optional) Specifies the IPv6 interface name.
<ipif_name 12> - Enter the IPv6 interface name used here. This name can be up to 12
characters long.
If no parameter is specified, the switch will display all (*, G) entries of the IPv6 multicast routing
table in brief.
Restrictions
None. (EI Mode Only Command)
Example
To show the whole IPv6 multicast routing table of (*, G) generated on the switch:
DGS-3620-28PC:admin# show pim6 mroute star_g
Command: show pim6 mroute star_g
(*, G) Entry Table
-------------------------
Group : FF13::100
Upstream : n2
RP Address : 3FFE:10:10::153
Group : FF13::101
Upstream : n2
RP Address : 3FFE:10:10::153
Group : FF13::102
Upstream : n2
RP Address : 3FFE:10:10::153
Total Entries: 3