PackTrack™
Reference Manual 231
4. Measure the distance for Y from the trigger (PS line) to the center of the
barcode (edge of the box), and enter that distance in the first box under Y-
Coord (mm).
Your measurements will likely differ from those shown below.
5. Measure the distance for Z from the conveyor bed to the center of the bar-
code, and enter that dist
ance in the first box under Z-Coord (mm).
Your measurements will likely differ from those shown below.
6. Click Calibrate 1. PackTrack data is displayed for the first code.
To make it easier to measure the Y-Coordinate, place a box along the photoelectric
sensor laser line (Trigger). Then the end of the tape measure or ruler can be place
against the edge of the box. See below.
To Next Page
Loading...
