Symbologies Enter/Exit Programming Mode
Product Reference Guide
121
Code 39 Set Length 1
This feature specifies one of the bar code lengths for Code 39 Length Control
on page 120. Length 1 is the minimum label length if in Variable Length on
page 120 Mode, or the first fixed length if in Fixed Length on page 120 Mode.
Length includes the bar code’s check, data, an
d ful
l-ASCII shift characters. The
length does not include start/stop characters.
The length can be set from 0 to 50 characters. See "Set Length 1" on page 245
for more detailed programming instructions.
Select Code 39 Set Length 1 Setting
To configure this feature, scan the ENTER/EXIT bar code
above, then the bar code at left followed by digits from
the Alphanumeric characters in
Appendix D, Key-
pad
representing your desired character(s). End by
scanning the ENTER/EXIT bar code again.
Make a mistake? Scan the CANCEL bar code to abort and
not save t
he entry string. You can then start again at the
beginning.
CANCEL
DEFAULT
02 = Length 1 is 2 Characters
$CC3L1
~
To Next Page
Loading...
Need help?
General
