Enter/Exit Programming Mode ACK NAK Options
30 Heron™ HD3130
ACK NAK Timeout Value
This option specifies the amount of time the scanner waits for an ACK character
from the host following label transmission. The selectable timeout range is 200
milliseconds to 15,000ms (15 seconds) in 200ms increments. A selection of 0
disables the timeout. See "ACK NAK Timeout Value" on
page 22
2 for more
detailed programming instructions.
Select ACK NAK Timeout Value Setting
To configure this feature, scan the ENTER/EXIT bar code
above, then the bar code at left followed by digits from
the Alphanumeric characters in
Appendix D, Key-
pad
representing your desired character(s). End by
scanning the ENTER/EXIT bar code again.
Make a mistake? Scan the CANCEL bar code to abort and
not save t
he entry string. You can then start again at the
beginning.
CANCEL
01 ACK NAK Timeout value is 200ms
$CR2AT
~
To Next Page
Loading...
Need help?
General
