Enter/Exit Programming Mode Intercode Delay
44 Heron™ HD3130
Intercode Delay
Specifies the delay between labels transmitted to the host for this interface. The
selectable range for this feature is from 0 to 99 seconds. See
"Intercode Delay"
on page 228 for more detailed programming instru
ctions.
Set Intercode Delay
To configure this feature, scan the ENTER/EXIT bar code
above, then the bar code at left followed by digits from the
Alphanumeric characters in
Appendix D, Keypad
representing your desired charac
ter(s). End by scanning
the ENTER/EXIT bar code again.
Make a mistake? Scan the CANCEL bar code to abort and
not save the entry string. You can then start again at the
beginning.
CANCEL
00 = No Wedge Intercode Delay
$CKBID
~
To Next Page
Loading...
