Datalogic Heron HD3100 User Manual

Enter/Exit Programming Mode RGB LED Settings
78 Heron™ HD3130
RGB Good Read Falling Time
Specifies the time for the RGB good read to change the status from the Bright-
ness state to the Off state.
See
"RGB Good Read Raising/Falling Time" on page 238 for more detailed program-
ming instructions.
Set RGB Good Read Falling Time
To configure this feature, scan the ENTER/EXIT bar code
above, then the bar code at left followed by digits from
the Alphanumeric characters in
Appendix D, Keypad
representing your desired character(s). End by scanning
the ENTER/EXIT bar code again.
M
ake a mistake? Scan the CANCEL bar code to abort and
not save t
he entry string. You can then start again at the
beginning.
CANCEL
DEFAULT
14 = 20 seconds Falling Time
RGB Good Read Holding Time
Specifies how long the RGB good read will stay in Brightness state. See "RGB
Good Read Holding Time"
on page 239 for more information.
Set RGB Good Read Holding Time
To configure this feature, scan the ENTER/EXIT bar code
above, then the bar code at left followed by digits from
the Alphanumeric characters in
Appendix D, Keypad
representing your desired character(s). End by scanning
the ENTER/EXIT bar code again.
M
ake a mistake? Scan the CANCEL bar code to abort and
not save
t
he entry string. You can then start again at the
beginning.
CANCEL
DEFAULT
14 = 20 seconds Holding Time
$CRBFT
~
$CRBHT
~

Datalogic Heron HD3100 Specifications

General

Brand	Datalogic
Model	Heron HD3100
Category	Barcode Reader
Language	English