Datalogic Heron HD3100 - Stand Mode Triggered Timeout

Reading Parameters Enter/Exit Programming Mode
Product Reference Guide 81
Stand Mode Triggered Timeout
This feature specifies the time to remain in “Trigger Single” mode after the trig-
ger is pulled while in “Stand Mode”.
NOTE
This timeout is only used when the Scan Mode is configured as Stand
Mode.
$CSNOT01
Stand Mode Triggered Timeout = 0.5 Seconds
$CSNOT03
Stand Mode Triggered Timeout = 1.5 Seconds
$CSNOT04
Stand Mode Triggered Timeout = 2 Seconds
DEFAULT
$CSNOT06
Stand Mode Triggered Timeout = 3 Seconds
$CSNOT08
Stand Mode Triggered Timeout = 4 Seconds
$CSNOT0C
Stand Mode Triggered Timeout = 6 Seconds