Product Reference Guide 17
Chapter 3
Configuration Using Bar Codes
This and following sections provide programming bar codes to configure your
scanner by changing the default settings. For details about additional methods
of programming, see "
Customizing Configuration Settings" on page 14
.
NOTE
You must first enable your scanner to read
bar codes in order to
use this section. If you have not done this, go to
Setup, starting on
page 5
and complete the appropriate procedure.
Configuration Parameters
Once the scanner is set up, you can change the default parameters to meet your
application needs. Refer to "
Resetting the Product Configuration to Defaults" on page
16
for initial configuration in order to set the default values and select the
interface for your application.
The following configuration parameters are divided into logical groups, making
it easy
to find the desired function based on its reference group.
Interface Configuration:
• "RS-232 ONLY Interface" on page 21
• "RS-232/USB-COM Interfaces" on page 25
• "Keyboard Interface" on page 35
• "USB-OEM Interface" on page 47
Parameters common to all interface applications:
• "
Global Prefix/Suffix" on page 50
• "
Data Format" on page 49
offers advanced configuration options for custom-
ization of scanned data output.
• "
Reading Parameters" on page 61
control various operating modes and indi-
cators status functioning.
Symbology-specific parameters:
"Symbologies" on page 85
defines options for all symbologies and provides the
programming bar codes necessary for configuring these features.
NOTE
You must first enable your scanner to read bar codes in order to
use this section. If you have not done this, go to
Setup, starting on
page 5
and complete the appropriate procedure.
To Next Page
Loading...
Need help?
General
