Datalogic Heron HD3100 User Manual

Setup
16 Heron™ HD3130
Resetting the Product Configuration to Defaults
If you aren't sure what programming options are in your scanner, or you've
changed some options and want to restore the Custom Default Configuration
that may have been saved in the scanner, scan the
Restore Custom Default Config-
uration
bar code below. This will restore the custom configuration for the cur-
rently active interface.
NOTE
$P,HA00,P
Restore Custom Default Configuration
Custom defaults are based on the interface type. Configure the scanner for
the correct interface before scanning this label.
If you aren't sure what programming options are in your scanner, or you've
changed some options and want to restore the Factory Configuration, you have
two options. You can scan the
Restore USA Factory Configuration bar code or the
Restore EU Factory Configuration bar code below. Both labels restore the scanner
configuration to the factory settings including the interface type. The USA label
rest
ores Label IDs to those historically used in the USA. The EU label restores
Label IDs to those historically used in Europe. The Label ID sets for USA and EU
are shown in the Label ID section of this manual.
CAUTION
Restore USA Factory Configuration
$P,AE,P
Restore EU Factory Configuration
$P,Ae,P
Scanning either of the “Restore Factory Configuration” commands below
will result in the loss of any custom configuration settings for your device.
The programming section on the following pages lists the factory default set-
tings for each of the menu commands (indicated by shaded blocks and bold
text).

Datalogic Heron HD3100 Specifications

General

Brand	Datalogic
Model	Heron HD3100
Category	Barcode Reader
Language	English