Reading Parameters
84 Heron™ HD3130
Flash Off Time
This feature specifies the OFF time for the indicator LED while in Flash Mode.
The selectable range is 100 to 9,900 milliseconds (0.1 to 9.9 seconds), in 100
millisecond increments. See
"Flash Off Time"
on page 244 for more detailed pro-
gramming instructions.
Select Flash OFF Time Setting
To configure this feature, scan the ENTER/EXIT bar code
above, then the bar code at left followed by digits from
the Alphanumeric characters in
Appendix D, Keypad
representing your desired character(s). End by scanning
the ENTER/EXIT bar code again.
M
ake a mistake? Scan the CANCEL bar code to abort and
not save t
he entry string. You can then start again at the
beginning.
CANCEL
DEFAULT
06 = Flash is OFF for 600ms
Stand Mode Sensitivity
Sets the sensitivity level for stand mode wakeup. Choices are low, medium and
high.
Stand Mode Sensitivity = Low
Stand Mode Sensitivity = Medium
DEFAULT
Stand Mode Sensitivity = High
$CSNFF
~
$CSMSE00
$CSMSE01
$CSMSE02
To Next Page
Loading...
