Enter/Exit Programming Mode Datalogic 2 of 5
150 Heron™ HD3130
Datalogic 2 of 5 Set Length 2
This feature specifies one of the bar code lengths for Datalogic 2 of 5 Length
Control on page 148. Length 2 is the maximum label length if in Variable
Length on page 142 Mode, or the second fixed le
ngth if in Fixed Length on
page 142 Mode. The length includes the bar code’s data char
acters only.
The length can be set from 2 to 50 characters. A setting of 00 specifies to
ignore this length (only one fixed length). See "Set Length 2" on page 24
7 for
more detailed programming instructions.
Select Datalogic 2 of 5 Length 2 Setting
To configure this feature, scan the ENTER/EXIT bar code
above, then the bar code at left followed by digits from
the Alphanumeric characters in
Appendix D, Key-
pad
representing your desired character(s). End by
scanning the ENTER/EXIT bar code again.
Make a mistake? Scan the CANCEL bar code to abort and
not save t
he entry string. You can then start again at the
beginning.
CANCEL
DEFAULT
50 = Length 2 is 50 Characters
$CD2L2
~
To Next Page
Loading...
Need help?
General
