Enter/Exit Programming Mode Scanning Features
82 Heron™ HD3130
Scanning Active Time
This setting specifies the amount of time that the reader stays in scan ON state
once the state is entered. The range for this setting is from 1 to 255 seconds in
1-second increments. See
"Scanning Active Time"
on page 242 for more detailed
programming instructions.
Select Scanning Active Time Setting
To configure this feature, scan the ENTER/EXIT bar code
above, then the bar code at left followed by digits from
the Alphanumeric characters in
Appendix D, Keypad
representing your desired character(s). End by scanning
the ENTER/EXIT bar code again.
M
ake a mistake? Scan the CANCEL bar code to abort and
not save
t
he entry string. You can then start again at the
beginning.
CANCEL
DEFAULT
005 = Scanning is active for 5 Seconds
Stand Mode Triggered Timeout (continued)
$CSNOT10
Stand Mode Triggered Timeout = 8 Seconds
$CSNOT00
Stand Mode Triggered Timeout = 0
Do Not Switch Back to Stand Mode
NOTE
When set to 0, the scanner will remain in single trigger mode after the trigger is
pulled. It will return to object sense mode after a reset.
$CSNET
~
To Next Page
Loading...
Need help?
General
