Reading Parameters Enter/Exit Programming Mode
Product Reference Guide
69
Select Audio Jingle for Enter Stand Mode
This parameter selects which preloaded Jingle to use in indicating an Enter
Stand Mode event.
NOTE
"Audio Jingle Enable"
on page 66 must be selected for this configuration
item to take effect.
After uploading up to fifteen (15) Jingles to the scanner using the Datalogic
Aladdin
™
configuration utility, use this setting to designate which of the Jingles
(1-15) will be sounded when the scanner enters Stand Mode.
Select Audio Jingle on Enter Stand Mode
To configure this feature, scan the ENTER/EXIT bar code
above, then the bar code at left followed by two digits
from the Alphanumeric characters in
Appendix D,
Keypad
representing the desired Jingle #. End by scan-
ning the ENTER/EXIT bar code again.
Make a mistake? Scan the CANCEL bar code to abort and
not save t
he entry string. You can then start again at the
beginning.
CANCEL
00 = Use built-in Enter Stand Mode indication
$CAUEM
~
To Next Page
Loading...
Need help?
General
