Datalogic Heron HD3100 - ACK Character; NAK Character

RS-232/USB-COM Interfaces Enter/Exit Programming Mode
Product Reference Guide 29
ACK Character
This setting specifies an ASCII character or hex value to be used as the ACK
character. ASCII characters or any hex value from 0 to 0xFF can be selected. See
"ACK Character" on page 22
0 for more detailed programming instructions.
NOTE
Select ACK Character Setting
DEFAULT
0x06 ‘ACK’ Character
Setting to previously defined characters such as XON, XOFF, or
host commands conflicts with normal operation of these char-
acters. 8-bit data is not recognized when the option
Stop Bits
on page 22
has been set as 7 Data Bits.
NAK Character
This setting specifies an ASCII character or hex value to be used as the NAK
character. ASCII characters or any hex value from 0 to 0xFF can be selected. See
"NAK Character" on pa
ge 221 for more detailed programming instructions.
NOTE
Select NAK Character Setting
DEFAULT
0x15 ‘NAK’ Character
Setting to previously defined characters such as XON, XOFF, or
host commands conflicts with normal operation of these char-
acters. 8-bit data is not recognized when the option
Stop Bits
on page 22
has been set as 7 Data Bits.
$CR2AC
$CR2NA