Symbologies Enter/Exit Programming Mode
Product Reference Guide
215
BC412 Set Length 2
This feature specifies one of the bar code lengths for BC412 Length Control on
page 214. Length 2 is the maximum label length if in Variable Length on page
214 Mode, or the second fixed length if in Fixed Length on page 214 Mode.
Length includes the bar code’s check, data, an
d ful
l-ASCII shift characters. The
length does not include start/stop characters.
The length can be set from 1 to 50 characters. A setting of 00 specifies to
ig
no
re this length (only one fixed length). See "Set Length 2" on page 24
7 for
more detailed programmi
ng instructions.
Select BC412 Length 2 Setting
To configure this feature, scan the ENTER/EXIT bar code
above, then the bar code at left followed by digits from
the Alphanumeric characters in
Appendix D, Key-
pad
representing your desired character(s). End by
scanning the ENTER/EXIT bar code again.
Make a mistake? Scan the CANCEL bar code to abort and
not save t
he entry string. You can then start again at the
beginning.
CANCEL
DEFAULT
50 = Length 2 is 50 Characters
$CBCL2
~
To Next Page
Loading...
Need help?
General
