Keyboard Interface Enter/Exit Programming Mode
Product Reference Guide
43
Intercharacter Delay
This parameter specifies the intercharacter delay between the end of one char-
acter and the beginning of the next. The delay can be set within a range of zero
(0) to
990 milliseconds in 10ms increments. A setting of zero specifies no
delay. See "Intercharacter Delay" on page 22
7 for more detailed programming
instructions.
Intercharacter Delay = No Delay
Select Intercharacter Delay Setting
To configure this feature, scan the ENTER/EXIT bar code
above, then the bar code at left followed by digits from the
Alphanumeric characters in
Appendix D, Keypad
representing your desired charac
ter(s). End by scanning
the ENTER/EXIT bar code again.
Make a mistake? Scan the CANCEL bar code to abort and not
save the entry string. You can then start again at the begin-
ning.
CANCEL
DEFAULT
00 = No Intercharacter Delay
$CR21C00
$CR21C
~
To Next Page
Loading...
Need help?
General
