Customizing Configuration Settings
Product Reference Guide
15
Interface Settings
The scanner is typically factory-configured with a set of default features stan-
dard to the interface type you ordered. See
"Interface Selection"
on page 11.
Global Interface Features, starting on page 19
provides settings configurable by all
interface types. If your installation requires you to further customize your scan-
ner, you can select other options through use of the instructions and program-
ming bar codes available in the appropriate section for your interface.
•
RS-232 ONLY Interface, starting on page 21
•
RS-232/USB-COM Interfaces, starting on page 25
•
Keyboard Interface, starting on page 35
•
USB-OEM Interface, starting on page 47
Configuring Other Features
If your installation requires different programming than the standard factory
default settings, the following sections of this manual allow configuration of
non-interface-specific settings you might require:
Configuration Using Bar Codes
:
General Features includes programming for scan-
ning, speaker and LED indicators and other such universal settings.
Reading Parameters
:
Reading Parameters include programming for scanning,
speaker and LED indicators and other universal settings.
Symbologies
:
Includes options concerning the bar code label types (symbolo-
gies). These settings allow you to enable/disable symbologies, set label
len
gths, require check digit, etc.
Software Version Transmission
The software version of the device can be transmitted over the RS-232, Key-
board and USB interfaces by scanni
ng the following label.
Transmit Software Version
RevA
To Next Page
Loading...
Need help?
General
