Enter/Exit Programming Mode Codabar
160 Heron™ HD3130
Codabar Set Length 1
This feature specifies one of the bar code lengths for Codabar Length Control
on page 159. Length 1 is the minimum label length if in Variable Length on
page 159 Mode, or the first fixed length if in Fixed Length on page 159 Mode.
Length includes the bar code’s start, stop, ch
eck an
d data characters. The
length must include at least one data character.
The length can be set from 3 to 50 characters. See "Set Length 1" on
page 24
5
for more detailed programming instru
ctions.
Select Codabar Length 1 Setting
To configure this feature, scan the ENTER/EXIT bar code
above, then the bar code at left followed by digits from
the Alphanumeric characters in
Appendix D, Key-
pad
representing your desired character(s). End by
scanning the ENTER/EXIT bar code again.
Make a mistake? Scan the CANCEL bar code to abort and
not save t
he entry string. You can then start again at the
beginning.
CANCEL
DEFAULT
03 = Length 1 is 3 Characters
$CCBL1
~
To Next Page
Loading...
Need help?
General
