Enter/Exit Programming Mode Label Gone Timeout
64 Heron™ HD3130
Label Gone Timeout
This feature sets the time after the last label segment is seen before the scan-
ner prepares for a new label. The timeout can be set within a range of 10 milli-
seconds to 2,550 milliseconds (2.55 seconds) i
n 10ms increments. Label Gone
Timeout does not apply to scan modes that require a trigger pull for each label
that is read. See "
Label Gone Timeout" on page 237
for more detailed program-
ming instructions.
Select Label Gone Timeout Setting
To configure this feature, scan the ENTER/EXIT bar code
above, then the bar code at left followed by digits from
the Alphanumeric characters in
Appendix D, Keypad
representing your desired character(s). End by scanning
the ENTER/EXIT bar code again.
M
ake a mistake? Scan the CANCEL bar code to abort and
not save
t
he entry string. You can then start again at the
beginning.
CANCEL
$CSNLG
~
To Next Page
Loading...
