Enter/Exit Programming Mode BC412
214 Heron™ HD3130
BC412 Length Control
This feature specifies either variable length decoding or fixed length decoding
for the BC412 symbology.
Variable Length:
For variable length decoding, a minimum and maximum length
may be set.
Fixed Length:
For fixed length decoding, two different lengths may be set.
DEFAULT
BC412 Length Control = Variable Length
BC412 Length Control = Fixed Length
BC412 Set Length 1
This feature specifies one of the bar code lengths for BC412 Length Control on
page 214
. Length 1 is the minimum l
abel length if in
Variable Length on page
214
Mode, or the first fixe
d length if in
Fixed Length on page 214 Mode. Length
includes the bar code’s data
characters only.
The length can be set from 01 to 50 characters. See
"Set Length 1" on page
245
for more detailed programming instru
ctions.
Select BC412 Set Length 1 Setting
To configure this feature, scan the ENTER/EXIT bar code
above, then the bar code at left followed by digits from
the Alphanumeric characters in
Appendix D, Key-
pad
representing your desired character(s). End by
scanning the ENTER/EXIT bar code again.
Make a mistake? Scan the CANCEL bar code to abort and
not save t
he entry string. You can then start again at the
beginning.
CANCEL
DEFAULT
01 = Length 1 is 1 Character
$CBCLC00
$CBCLC01
$CBCL1
~
To Next Page
Loading...
