Scanning Features
Product Reference Guide
83
Stand Mode Flash
Enables/disables the LED flash when the reader is in Stand Mode.
Flash On Time
This feature specifies the ON time for the indicator LED while in Flash Mode.
The selectable range is 100 to 9,900 milliseconds (0.1 to 9.9 seconds), in 100
millisecond increments. See
"Flash On Time"
on page 243 for more detailed pro-
gramming instructions.
Select Flash ON Time Setting
To configure this feature, scan the ENTER/EXIT bar code
above, then the bar code at left followed by digits from
the Alphanumeric characters in
Appendix D, Keypad
representing your desired character(s). End by scanning
the ENTER/EXIT bar code agai
n.
Make a mistake? Scan the CANCEL bar code to abort and
not save t
he entry string. You can then start again at the
beginning.
CANCEL
DEFAULT
10 = Flash is ON for 1 Second
$CSMFL00
Stand Mode Flash = Disable
$CSMFL01
Stand Mode Flash = Enable
$CSNFN
~
To Next Page
Loading...
