Enter/Exit Programming Mode Wedge Quiet Interval
42 Heron™ HD3130
Wedge Quiet Interval
This option specifies the amount of time to look for keyboard activity before
the scanner breaks the keyboard connection in order to transmit data to host.
The selectable range for this feature is from 0 to 990ms in 10ms increments.
See "Wedge Quiet Interval" on
pa
ge 226 for more detailed programming
instructions.
NOTE
Select Wedge Quiet Interval Setting
To configure this feature, scan the ENTER/EXIT bar code
above, then the bar code at left followed by digits from the
Alphanumeric characters in
Appendix D, Keypad
representing your desired charac
ter(s). End by scanning
the ENTER/EXIT bar code again.
Make a mistake? Scan the CANCEL bar code to abort and
not save the entry string. You can then start again at the
beginning.
CANCEL
DEFAULT
10 = Quiet Interval of 100 ms
This feature applies ONLY to the Keyboard Wedge interface.
$CKBQI
~
To Next Page
Loading...
Need help?
General
