Symbologies Enter/Exit Programming Mode
Product Reference Guide
143
I 2 of 5 Set Length 1
This feature specifies one of the bar code lengths for I 2 of 5 Length Control on
page 142
. Length 1 is the minimum l
abel length if in
Variable Length on page
148
Mode, or the first fixed length if in Fixed Length on page 148 Mode. The
length includes the bar code’s check and data characters
.
The length can be set from 2 to 50 characters in increments of two. See
"Set
Length 1"
on pa
ge 245 for more detailed programming instructions.
Select I 2 of 5 Length 1 Setting
To configure this feature, scan the ENTER/EXIT bar code
above, then the bar code at left followed by digits from
the Alphanumeric characters in
Appendix D, Key-
pad
representing your desired character(s). End by
scanning the ENTER/EXIT bar code again.
Make a mistake? Scan the CANCEL bar code to abort and
not save
t
he entry string. You can then start again at the
beginning.
CANCEL
DEFAULT
06 = Length 1 is 6 Characters
$CI2L1
~
To Next Page
Loading...
