Enter/Exit Programming Mode
18 Heron™ HD3130
To program features:
1. Scan the ENTER/EXIT PROGRAMMING bar code, available at the top of each
programming page, when applicable.
2. Scan the bar code to set the desire
d pr
ogramming feature. You may need
to cover unused bar codes on the page, and possibly the facing page, to
ensure that the scanner reads only the bar code you intend to scan.
3. If additional input parameters ar
e needed, go to
Appendix D, Keypad
, and
scan the appropriate characters from the keypad.
NOTE
Additional information about many features can be found in the “Ref-
erences” chapter.
If you make a mistake before the last character, scan the CANCEL bar
code to abor
t and not save the entry string. You can then start again at
the beginning.
4. Complete the programming sequence by scanning the ENTER/EXIT PRO-
GRAMMING bar code to exit
Programming Mode.
For more detailed descriptions, programming information and
examples for
setting selected configuration items, see
References, starting on page 217
.
To Next Page
Loading...
