References
234 Heron™ HD3130
Label ID: Set Individually Per Symbology
To configure a Label ID individually for a single symbology:
1. Scan the ENTER/EXIT bar code.
2. Select Label ID position as either BEFORE (Enable as
Prefix) or AFTER
(Enable as suffix) by scanning the appropriate bar code in the section
"Label ID Control"
on page 53. Reference Figure 7 for Label ID positioning
options if multiple identification features are enabled.
3. Scan a bar code to select the symbology for which you wish to configure a
cu
st
om Label ID from the section
Label ID Symbology Selection, starting on
page 54
.
4. Determine the desired character(s) (you may choose up to three) which will
represe
nt the Label ID for the selected symbology.
5. Turn to the
ASCII Chart on page 287
on the inside back cover of this manual
and find the equivalent hex digits associated with
your choice of Label ID.
For example, if you wish to select an equal sign (=) as a Label ID, the chart
indicates its associated hex characters as 3D. Turn to
Keypad, starting on
page 275
and scan the bar codes representing the hex characters deter-
mined. For the example given, the characte
rs ‘3’ and ‘D’ would be
scanned. More examples of Label ID settings are provided in
Table 13
.
NOTE
If you make a mistake before the last character, scan the CANCEL bar
code to abort and
not save the entry string. You can then start again at
the beginning.
6. Scan the ENTER/EXIT bar code to exit Label ID entry.
7. Scan the ENTER/EXIT bar code once again to
exit Programming Mode.
This completes the steps to configure a
Label ID for a given symbology.
Figure 7. Label ID Position Options
OR
Prefix SuffixLabel ID Label IDBar Code DataAim ID
To Next Page
Loading...
