286 Configuring Switching Information
Enabling Ingress Backpressure
1.
Open the
Ports Global Parameters
page.
2.
Select Enable from the drop-down menu in the
Flow Control
field.
3.
Click
Apply Changes
.
4.
Ingress backpressure is now enabled.
Configuring Flow Control Using the CLI Commands
For information about the CLI commands that perform this function, see the following chapter in the
CLI Reference Guide
:
• Ethernet Configuration Commands
Port Configuration
Use the Port Configuration page to define port parameters.
To display the Port Configuration page, click Switching > Ports > Port Configuration in the tree view.
To Next Page
Loading...
