Dell PowerConnect M8024 - Page 290

288 Configuring Switching Information
– Full — Indicates that the interface supports transmission between the switch and the client in
both directions simultaneously.
•
Current Duplex Mode — Displays the synchronized port duplex mode.
•
Auto Negotiation — Enables Auto Negotiation on the port. Auto Negotiation is a protocol between
two link partners that enables a port to advertise its transmission rate, duplex mode, and flow control
abilities to its partner.
•
Current Auto Negotiation — Displays the current Auto Negotiation setting.
•
Admin Advertisement — Specifies the capabilities advertised by the port. The field values include:
•
LAG — Displays LAG number if this port is a member of a LAG.
•
Current Flow Control — Indicates the current Flow Control settings. Possible field values are:
–
Active — Flow Control is active.
–
Inactive — Flow Control is inactive.
•
Transceiver Firmware Version — Displays firmware part number of port transceiver, if available. Valid
only for SFX7101 transceivers on 10GBase-T non-stacking ports.
•
Image Firmware Version — Displays the version of the image on the firmware.
•
Firmware Update Status — Indicates the statue of the firmware on the switch:
–
Up-to-date — The firmware status is current.
–
Outdated — The firmware status is not current.
•
Max. Cable Length — Displays the maximum cable length determined by current power backoff level.