Dell PowerConnect M8024 - Page 447

Viewing Statistics and Remote Monitoring 445
Removing One Alarm Table Entry
1. Open the RMON Alarms page.
2. Select an entry in the Alarm Entry drop-down menu.
3. Check the Remove check box and click Apply Changes .
The entry is removed, and the device is updated.
Removing Multiple Alarm Table Entries
1. Open the RMON Alarms page.
2. Click Show All.
The RMON Alarms Table displays.
3. Check Remove for each Alarm Entry to remove.
4. Click Apply Changes .
The entries are removed, and the device is updated.
Defining Switch Alarms Using the CLI Commands
For information about the CLI commands that perform this function, see the following chapter in the
CLI Reference Guide :
• RMON Commands