Dell PowerConnect M8024 - Page 557

Configuring Routing 555
Removing a Loopback
1. Open the Loopback Configuration page.
2. Specify the loopback to remove in the Loopback drop-down menu.
3. Click Delete Loopback .
The loopback is deleted, and the device is updated.
Removing a Secondary Address
1. Open the Loopback Configuration page.
2. Specify the loopback to be affected.
3. Specify the secondary address to be removed.
4. Click Delete Selected Secondary .
The secondary address is deleted, and the device is updated.
Configuring a Loopback using CLI Commands
For information about the CLI commands that perform this function, see the following chapters in the
CLI Reference Guide:
• Loopback Interface Commands
• IP Addressing Commands
• IPv6 Routing Commands