594 Configuring IPv6
•
Create New Area Range
— Click this check box to create a new OSPFv3 area range using the values
you specified.
•
Area ID
— The OSPFv3 area.
•
IPv6 Prefix
— The IPv6 Prefix of an address range for the area.
•
LSDB Type
— The Link Advertisement type for the address range and area.
•
Advertisement
— The Advertisement mode for the address range and area.
•
Delete
— Click this check box to delete the specified OSPFv3 area range.
Configuring OSPFv3 Area Range
1.
Open the
OSPFv3 Area Range Configuration
page.
2.
Modify the fields as needed.
3.
Click
Apply Changes
.
The OSPFv3 area range is saved, and the device is updated.
Configuring OSPFv3 Area Range using the CLI Command
For information about the CLI commands that perform this function, see the following chapter in the
CLI Reference Guide
:
• OSPFv3 Commands
To Next Page
Loading...
