Configuring IP Multicast 659
Configuring a Static Route
1.
Open the
Static Routes
page.
2.
Select
Create Static Route
in the
Source
field to configure a new static entry, or select one of the
existing entries.
3.
Modify the remaining fields as needed.
4.
Click
Apply Changes
.
The new or modified static route is saved, and the device is updated.
Configuring a Static Route the CLI Commands
For information about the CLI commands that perform this function, see the following chapter in the
CLI Reference Guide:
• Multicast Commands
Multicast Static Routes Summary
Use the Multicast Static Routes Summary
page to display static routes and their configurations.
To display the page, click IP Multicast > Multicast > Static Routes Summary in the tree view.
Figure 12-5. Multicast Static Routes Summary
To Next Page
Loading...
