Configuring IP Multicast 705
Configuring PIM-DM for an Interface
1.
Open the
PIM-DM Interface Configuration
page.
2.
Select the interface to configure from the
Interface
field.
3.
Modify the remaining fields as needed.
4.
Click
Apply Changes
.
The interface configuration is saved, and the device is updated.
Configuring PIM-DM for an Interface using the CLI Command
For information about the CLI commands that perform this function, see the following chapter in the
CLI Reference Guide:
• PIM-DM Commands
PIM-DM Interface Summary
Use the PIM-DM Interface Summary
page to display a PIM interface and its settings.
To display the page, click IPv4 Multicast > PIM > Interface Summary or IPv6 Multicast > PIM >
Interface Summary in the tree view.
Figure 12-37. PIM Interface Summary
To Next Page
Loading...
