Dell SC8000 - Page 161

Complete the Startup Wizard
Dell Compellent 151
d ClickContinue.Thepagethatappearsnextdependsonwhetherthereareany iSCSI
transportsinvirtualportmode:
 iSCSIinvirtualportmode:ArequestisdisplayedtoprovidetheIPaddress
informationrequiredtocreatethedefaultiSCSIFaultDomain.GotoStep 2 on
page 151.
 iSCSIinleg acy portmode(ornoiSCSIports):Whiletheinitialport
configurationisbeinggenerated,theStartupWizarddisplaysapageshowing
progress.Aftertheconfigurationhasbeengenerated,itisautomatically
validated.Ifthevalidationissuccessful,theconfirmationpageappears.Ifthere
areissues,apage
appearslistingerrormessages.GotoStep 3onpage 152.
2 (iSCSIvirtualportmodeonly)ConfigurethecontrolportfortheiSCSIfaultdomain.
a EntertheIPaddress,netmask,gateway,andportforthecontrolportforthenew
iSCSIfaultdomain.Checkthepre‐installationdocumentationforthisaddress.
b Click
Continue.
TheStartupWizardgeneratesthenewiSCSIfaultdomainandtheinitialport
configuration.Whiletheinitialportconfigurationisbeinggenerated,theStartup
Wizarddisplaysapageshowingprogress.Aftertheconfigurationhasbeen
generated,itisautomaticallyvalidated.
 Ifthereareissues,anerrormessagepageappears.
 Ifthevalidationissuccessful,aconfirmationpageappears.