EasyManua.ls Logo

Dodge Neon 2001 - WITH MANUAL TRANSAXLE

Dodge Neon 2001
743 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
(8) Remove the two remaining nuts fastening the
brake pedal bracket to the power brake booster (Fig.
11).
(9) If the vehicle is equipped with antilock brakes,
carefully push the power brake booster forward until
the booster contacts the ABS ICU mounting bracket.
(10) If the vehicle does not have antilock brakes,
carefully push the power brake booster forward one
to two inches being careful not to stretch the brake
lines from the master cylinder to the brakes.
(11) Remove the two nuts fastening the brake
pedal bracket to the instrument panel support (Fig.
11).
(12) Carefully remove the brake pedal assembly by
pulling the pedal bracket back toward the instru-
ment panel, releasing the bracket from the booster
studs. Next, tip the bracket down past the input rod,
guiding the rod through the gap left by the missing
brace removed in Step (8). Remove the brake pedal
assembly out from under the instrument panel.
(13) The pedal can be removed from it’s bracket by
grinding off the peened end of the shaft, removing
the shaft, pedal and bushings. A service parts pack-
age is available to replace these items.
WITH MANUAL TRANSAXLE
(1) Remove the instrument panel. (Refer to 23 -
BODY/INSTRUMENT PANEL/INSTRUMENT
PANEL ASSEMBLY - REMOVAL).
(2) Remove the brake lamp switch. (Refer to 8 -
ELECTRICAL/LAMPS/LIGHTING - EXTERIOR/
BRAKE LAMP SWITCH - REMOVAL)
(3) Disconnect the clutch cable from the clutch
pedal spacer (Fig. 12).
(4) Disconnect the wiring harness connector going
to the clutch pedal switches (Fig. 13).
(5) Remove the clip securing the power brake
booster input rod to the brake pedal. Remove the
input rod from the brake pedal.
Fig. 10 Steering Column Couplings
1 - STEERING COLUMN UPPER COUPLING
2 - PINCH BOLT
3 - STEERING COLUMN LOWER COUPLING
4 - BRAKE PEDAL
5 - NUT
6 - RETAINER PIN
Fig. 11 Brake Pedal Mounting
1 - CLUTCH CABLE
2 - BOOSTER MOUNTING NUTS
3 - UPPER MOUNTING NUTS
Fig. 12 Clutch Cable Connection
1 - SNAP RING
2 - CLUTCH PEDAL SPACER
3 - CLUTCH PEDAL
4 - CLUTCH CABLE
PL BRAKES-BASE 5s - 13
PEDAL (Continued)
ProCarManuals.com
2001 NEON

Table of Contents

Related product manuals