Dodge Neon 2001 - RETRACTED MIRROR SWITCH CIRCUIT TEST; REMOVAL; INSTALLATION

RETRACTED MIRROR SWITCH CIRCUIT TEST
NOTE: MIRROR POSITION SWITCH MUST BE IN
THE “FOLD” POSITION TO USE CHART BELOW.
WOBBLE
PLATE
POSITION
LEFT MIRROR
SELECTED
RIGHT
MIRROR
SELECTED
CONTINUITY
BETWEEN
PINS
CONTINUITY
BETWEEN
PINS
↓ 1-3-4-9 3-4-6-9
↑ 1-3-4-9 3-4-6-9
→ 2-3-4-9 3-4-7-9
2-3-4-9 3-4-7-9
REMOVAL
(1) Disconnect and isolate the battery negative
cable.
(2) Using a trim stick (special tool #C-4755) or
equivalent, gently pry up on window switch bezel
and remove from door trim panel (Fig. 3).
(3) Disconnect wire connector from switch.
(4) Remove two switch retaining screws (Fig. 4).
INSTALLATION
(1) Install switch to trim bezel. Install two switch
retaining screws.
(2) Connect wire connector to switch.
(3) Press trim bezel into door trim panel.
(4) Connect battery negative cable.
Fig. 3 Power Fold-Away Mirror Switch
1 - DOOR TRIM PANEL
2 - SWITCH BEZEL
3 - POWER FOLD-AWAY SWITCH
Fig. 4 Power Fold-Away Mirror Switch Mounting
1 - ELECTRICAL CONNECTOR
2 - RETAINING SCREWS
PL POWER MIRRORS 8Ns - 9
POWER FOLDAWAY MIRROR SWITCH (Continued)
ProCarManuals.com
2001 NEON