Dodge Neon 2001 - FLOOR CONSOLE; REMOVAL; INSTALLATION

FLOOR CONSOLE
REMOVAL
(1) Fully apply parking brake.
(2) Remove screw cover plugs over screws just
rearward of cup holders.
(3) Remove screws in cup holders attaching con-
sole to floor bracket (Fig. 3).
(4) Open console storage compartment lid, if so
equipped.
(5) Remove screws attaching console to floor
bracket.
(6) Remove shift lever knob, if vehicle is equipped
with a manual transmission.
(7) Lift console upward over gear selector and park
brake handle.
(8) Remove console from vehicle.
INSTALLATION
(1) Place floor console into position in vehicle.
(2) Install screws attaching console to floor brack-
ets.
(3) Install shift lever knob, if vehicle is equipped
with a manual transmission.
(4) Release parking brake.
Fig. 2 Turning Loop to Belt Adjuster
1 - FRONT SHOULDER BELT ADJUSTER
2 - TAB IS ON BOTTOM
Fig. 3 Floor Console
1 - FLOOR CONSOLE WITH ARMREST
2 - ATTACHING SCREWS
PL INTERIOR 23s - 13
B-PILLAR TRIM (Continued)
ProCarManuals.com
2001 NEON