(2) Push downward on Child Tether Assembly Cap
Cover till it locks into position (will hear part click
into position)
FRONT SEAT BELT &
RETRACTOR
REMOVAL
CAUTION: Front seat belt assemblies must be
replaced after a collision.
(1) Remove B-pillar trim.
(2) Remove bolt attaching seat belt retractor to
B-pillar (Fig. 8).
(3) Disconnect the wire connector to the retractor.
(4) Remove seat belt retractor from vehicle.
INSTALLATION
CAUTION: Front seat belt assemblies must be
replaced after a collision.
(1) Connect the wire connector to the retractor.
(2) Install seat belt retractor into vehicle.
(3) Install bolt attaching seat belt retractor to
B-pillar. Tighten seat belt anchor bolt to 40 N·m (30
ft. lbs.) torque.
(4) Install B-pillar trim.
PASSENGER AIRBAG
DESCRIPTION
The passenger airbag (Fig. 9) is located behind the
passenger airbag cover, between the glove box and
instrument panel top cover.
The passenger airbag includes an aluminum hous-
ing within which the cushion and inflator are
mounted and sealed. Two stamped metal brackets,
one on each end of the housing, enclose the cushion
Fig. 6 CHILD TETHER ASSEMBLY CAP
1 - CHILD TETHER ASSEMBLY CAP AND COVER
Fig. 7 CHILD TETHER ASSEMBLY CAP
1 - Cap cover
Fig. 8 FRONT SEAT BELT RETRACTOR
1 - FRONT SEAT BELT ADJUSTER
2 - UPPER B-PILLAR TRIM PANEL
3 - ADJUSTER BUTTON
4 - TURNING LOOP
5 - SEAT BELT
6 - SEAT BELT RETRACTOR
7 - ANCHOR BOLT
8 - LOWER B-PILLAR TRIM PANEL
PL RESTRAINTS 8Os - 5
CHILD TETHER (Continued)
ProCarManuals.com
To Next Page
Loading...
