POWER MIRRORS
TABLE OF CONTENTS
page page
POWER FOLDAWAY MIRROR
DIAGNOSIS AND TESTING ..................7
POWER FOLDAWAY MIRROR ..............7
REMOVAL ...............................7
POWER FOLDAWAY MIRROR SWITCH
DESCRIPTION............................8
OPERATION .............................8
DIAGNOSIS AND TESTING ..................8
POWER FOLDAWAY MIRROR SWITCH .......8
REMOVAL ...............................9
INSTALLATION............................9
POWER FOLDAWAY MIRROR
DIAGNOSIS AND TESTING - POWER
FOLDAWAY MIRROR
The following test is designed to test the fold-away
mirror motor inside the side view mirror.
NOTE: Battery must be fully charged prior to per-
forming this test.
(1) Remove the appropriate door trim panel retain-
ing fasteners.
(2) Remove power mirror electrical connector push-
pin from inner door panel.
(3) Disconnect mirror electrical connector and posi-
tion as shown.
(4) Depress the mirror “fold” switch and using a
voltmeter check pin # 7 for 12v. If battery voltage is
not present check wiring and or fuse for open. Refer
to Wiring Diagrams for a complete schematic of the
mirror fold-away system.
(5) Depress the mirror “unfold” switch and using a
voltmeter check pin # 4 for 12v. If battery voltage is
not present check wiring and or fuse for open. Refer
to Wiring Diagrams for a complete schematic of the
mirror fold-away system.
(6) Check for ground at pin # 3. If ground is not
present, check wiring for open. Refer to Wiring Dia-
grams for a complete schematic of the mirror fold-
away system.
(7) If the test above concluded that 12v is present
at pin # 7 and pin # 4, and a good ground is present,
the system up to the mirror is functioning properly.
Replace the side view mirror assembly.
REMOVAL
For service procedures, (Refer to 23 - BODY/EXTE-
RIOR/SIDE VIEW MIRROR - REMOVAL).
Fig. 1 Power Mirror Electrical Connector
PL POWER MIRRORS 8Ns - 7
ProCarManuals.com
To Next Page
Loading...
