REMOTE KEYLESS ENTRY
MODULE
REMOVAL
(1) Disconnect and isolate the battery negative
cable (Fig. 1).
(2) Remove the instrument panel top cover. Refer
to Body, Instrument Panel, Instrument Pane Top
Cover, Removal.
(3) Remove the two screws holding the RKE mod-
ule to the instrument panel assembly (Fig. 3).
(4) Slide locking tab of the wiring connector side-
ways to unlock tab, and remove connector from RKE
module.
(5) Remove RKE module from vehicle.
NOTE: When replacing a faulty RKE Module, the
replacement module must be configured with the
DRB lllT scan tool for proper operation. Refer to
Electrical, Vehicle Theft/Security, Standard Proce-
dure - Switching Operating Modes/Configuring a
New Module. Additionally, all transmitters must be
reprogrammed to the new RKE module.
INSTALLATION
NOTE: When replacing a faulty RKE Module, the
replacement module must be configured with the
DRB lllT scan tool for proper operation. Refer to
Electrical, Vehicle Theft/Security, Standard Proce-
dure - Switching Operating Modes/Configuring a
New Module. Additionally, all transmitters must be
reprogrammed to the new RKE module.
(1) Install the RKE module into the vehicle.
(2) Connect the RKE wiring connector.
(3) Install the two screws holding the RKE module
to the instrument panel assembly (Fig. 3).
(4) Install the instrument panel top cover. Refer to
Body, Instrument Panel, Instrument Pane Top Cover,
Installation.
(5) Connect the battery negative cable (Fig. 1).
Fig. 3 RKE MODULE LOCATION
1 - RKE MODULE
8Ns - 6 POWER LOCKS PL
ProCarManuals.com
To Next Page
Loading...
