(23) Disconnect the one instrument panel wire
harness connector.
(24) Disconnect the one vacuum harness connector.
(25) Pull HVAC control head out of instrument
panel, twist 90° and push back through the opening
(Fig. 3). Do not disconnect the control cables.
(26) Disconnect the center console wiring:
• Airbag Control Module (ACM)
• Parking Brake Warning Lamp Switch
• Transmission Range Indicator Lamp
• Shift Interlock Cable (ATX)
(27) With help on an assistant, remove two bolts
on top of the brake pedal support bracket. Pull rear-
ward on instrument panel assembly and remove from
vehicle.
(28) Remove center A/C duct from the instrument
panel (Fig. 5).
If replacing instrument panel, transfer parts (Fig.
4) as necessary.
INSTALLATION
If replacing instrument panel, transfer parts from
old instrument panel as necessary.
(1) With help on an assistant, place instrument
panel assembly into vehicle and onto the roll down
bolts.
(2) Feed the HVAC control into its opening in the
back of the panel. Align the 75-way electrical connec-
tor and carefully guide the panel into position on the
dash.
Fig. 1 A-PILLAR DOOR HARNESS CONNECTOR
1 - INSTRUMENT PANEL HARNESS CONNECTOR
2 - DOOR CHECK STRAP
3 - DOOR HARNESS CONNECTOR
Fig. 2 INSTRUMENT PANEL TO HVAC HARNESS
CONNECTORS
1 - HVAC HARNESS CONNECTORS
Fig. 3 HVAC CONTROL HEAD
1 - HVAC CONTROL HEAD
2 - RADIO
3 - HVAC CONTROL HEAD HARNESS CONNECTOR
23s - 8 INSTRUMENT PANEL PL
INSTRUMENT PANEL ASSEMBLY (Continued)
ProCarManuals.com
To Next Page
Loading...
