Dodge Neon 2001 - Page 57

(8) Remove shift cable-to-bracket clips (Fig. 23).
(9) Disconnect shift selector and crossover cable
from levers (Fig. 23). Remove cables and secure out
of the way.
(10) Disconnect the vehicle speed sensor connector
(Fig. 24).
(11) Raise vehicle on hoist.
(12) Remove transaxle oil drain plug and drain oil
into a suitable container.
(13) Remove both axle shafts. (Refer to 3 - DIF-
FERENTIAL & DRIVELINE/HALF SHAFT -
REMOVAL)
(14) Remove structural collar (Fig. 25).
(15) Remove the left engine-to-transaxle lateral
bending brace (Fig. 25).
(16) Remove bellhousing dust cover (Fig. 25).
(17) Remove the right engine-to-transaxle lateral
bending brace (Fig. 26).
(18) Remove starter motor (Fig. 27).
(19) Remove drive plate-to-clutch module bolts.
(20) Support engine at oil pan with screw jack and
wood block.
Fig. 22 Disconnect Hydraulic Circuit Using Tool
6638A
1 - QUICK CONNECT FITTING
2 - TOOL 6638A
Fig. 23 Shift Cables at Transaxle
1 - SHIFT CABLES
2 - CLIPS
3 - BRACKET
Fig. 24 Vehicle Speed Sensor Connector
1 - CONNECTOR
2 - SENSOR
3 - O-RING
4 - SPEEDO PINION
6s - 12 CLUTCH PL
MODULAR CLUTCH (Continued)
ProCarManuals.com
2001 NEON