(2) Install transaxle oil filter (Fig. 352). Inspect
the o-ring and replace if necessary.
(3) Ensure the transaxle oil pan and transaxle
case sealing surfaces are clean and dry. Install an
1/8” bead of Mopart Silicone Rubber Adhesive Seal-
ant to the oil pan and install (Fig. 353). Torque oil
pan-to-transaxle case bolts (Fig. 354) to 19 N·m (165
in. lbs.).
(4) Lower vehicle.
(5) Connect transmission range sensor connector.
(6) Install manual valve lever to manual shaft.
(7) Install gearshift cable to manual valve lever.
(8) Install air cleaner/throttle body assembly.
(9) Connect battery negative cable.
(10) Fill transaxle with Mopart ATF +4 Transmis-
sion fluid. (Refer to 21 - TRANSMISSION/TRANS-
AXLE/AUTOMATIC - 41TE/FLUID - STANDARD
PROCEDURE)
Fig. 352 Oil Filter
1 - OIL FILTER
2 - O-RING
Fig. 353 Oil Pan
1 - OIL PAN
2 - 1/8 INCH BEAD OF RTV SEALANT
3 - OIL FILTER
Fig. 354 Oil Pan Bolts
1 - OIL PAN BOLTS (USE RTV UNDER BOLT HEADS)
PL 41TE AUTOMATIC TRANSAXLE 21s - 205
VALVE BODY (Continued)
ProCarManuals.com
To Next Page